CONDTROL NEO X200 Bedienungsanleitung Seite 10

EN
LASER LEVEL
OPERATION
Before start operation remove the battery cover, insert the batteries,
observing correct polarity. Put battery cover back.
Use alkaline batteries only. Both batteries should be of the same type
and brand with the same charge level. If indicator
red while operation replace the batteries.
Place an instrument on a firm and stable surface or a tripod.
Move the switch bar to activate necessary operating mode:
1) Automatic leveling mode
Move the switch bar to ON position
The indicator
If the instrument is out of the range of automatic compensation it will
emit sound signal.
Short press button
Short press
green. Short press
To switch off the instrument move the switch bar to OFF position
2) Projection of inclined lines
Move the switch bar to OFF position
Indicator turns red.
Long press button
laser lines. Long press
mode. Indicator
switch off pulse mode.
10 10
turns green.
to switch on laser lines.
to switch on pulse mode. Indicator
again to switch off pulse mode.
during 3 seconds to switch on/off required
will be green. Long press
CONDTROL NEO X200
. The pendulum is unlocked.
. The pendulum is locked.
during 3 seconds to switch on pulse
user manual
starts flashing
will be
.
again to