Before Start Operation; Operation - CONDTROL XLiner Pento 360 Bedienungsanleitung

Pento 360 / Quattro 360 G /Pento 360 G
EN
CROSS LINE LASER

BEFORE START OPERATION

Power supply
The laser level is powered via a 7.4V 2600mAh Li-ion battery included
in the delivery package.
Install/charge the Li-ion battery
Install the battery in the battery compartment, observing the polarity.
Use the battery included in the delivery package only.
If the power indicator on the control panel starts flashing red, the
battery must be charged.
The charging procedure is as follows:
1) Remove the battery from the laser level.
2) Connect the battery to the power source by a charging cable,
included in the delivery package. The power indicator on control
panel will be red while charging.
3) The battery charging time is about 3 hours.
4) Once the power indicator on control panel turns green, disconnect
the charger and install the battery in the battery compartment.

OPERATION

Place the laser level on a firm and stable surface or a tripod.
Move switch bar to select required operating mode:
1) Automatic leveling:
Move the switch bar to position ON.
The laser level will switch on.
Short press
of the range of automatic compensation laser lines will flash 1 time
per second.
Short press
To switch off the laser level move the switch bar to position OFF.
to switch on required lines. If the laser level is out
to switch on/off the pulse mode.
user manual
9 9