marposs TESTAR Quick read M Installations- Und Bedienungsanleitung Seite 191

STRING
↵
?
↵
ID?
↵
VER?
↵
UNI?
↵
mm
↵
in
↵
M?
↵
S?
↵
M+S?
↵
Z
↵
UTOL?
↵
LTOL?
↵
MASTER?
↵
NOMVAL?
↵
DMAX
↵
DMIN
↵
DDIFF
↵
DMEAN
↵
DSEMI
↵
DCYCL
ASCII SERIAL TRANSMISSION PROTOCOL
SHORT DESCRIPTION
Measure Request to a Selected QuickRead
Machine Builder and Type Request to a Selected QuickRead
Software Version Request to a Selected QuickRead
Measuring Unit Request to a Selected QuickRead
Set-Up of Metric Unit to a Selected QuickRead
Set-Up of Imperial Unit to a Selected QuickRead
Measure Request to a Selected QuickRead
Measure Status Request to a Selected QuickRead
Measure and Status Request to a Selected QuickRead
Zeroing Request to a Selected QuickRead
Upper Tolerance Request to a Selected QuickRead
Lower Tolerance Request to a Selected QuickRead
Master Request to a Selected QuickRead
Nominal Value Request to a Selected QuickRead
Select Dynamic Type Measure of Maximum to a Selected
QuickRead
Select Dynamic Type Measure of Minimum to a Selected
QuickRead
Select Dynamic Type Measure of Maximum - Minimum to a
Selected QuickRead
Select Dynamic Type Measure of (Maximum + Minimum)/2 to
a Selected QuickRead
Select Dynamic Type Measure of (Maximum - Minimum)/2 to
a Selected QuickRead
Start/Stop for Dynamic Cycle of Selected Measure to a
Selected QuickRead
191