Werbung
Failure
(4)The pump furs after a short
period of time (approx. 2 to
3 months).
(5)The pump has seized, and
the driver of the Turbelle
stream 6100 sounds a
continuous tone.
(6)Dry run of the pump; short-
term operation without
water; the Turbelle
6100 sounds acontinuous
beep.
Cause
Excessively high lime additions
due to oversaturated salt water,
for example, cause lime
deposits on the bearing parts.
The drive unit or the hydro
®
propeller has jammed due to
wear, lime or snail housing, for
example.
The water level has dropped
considerably.
®
stream
Remedy
Reduce the lime additive or
submerge the pump in a 10 l
(2.6 gal.) bucket, half full with
water and 20 ml (.04 pt) of
vinegar essence. Permit the
pump to run for one to two
hours.
Avoid
Subsequently, thoroughly rinse
in tap water.
Remove the foreign body. Clean
the pump, and replace the drive
unit, if and when necessary. The
pump will start operating again
automatically after a delay of 20
seconds.
Top the tank up with sufficient
water or submerge pump
further.
splashes!
53
Werbung
