Werbung
Initial operation: Turbelle
- Operate the transformer (3) on a mains (5) of
230 VAC, 50 Hz (USA: 115 VAC, 60 Hz).
- Plug the cable plugs of the pump (1), the single
controller 7091 (4), and the transformer (3)
into the corresponding sockets of the
driver (2), and subsequently connect the
transformer (3) up to the mains.
- Turbelle
®
stream kits 6110 consist of Turbelle
stream 6100 and single controller 7091 (4).
- The pumps are connected directly to multi-
controller 7094 / single controller 7091.
- The connection to multi-controller 7093 / 7092
is possible only with converter 7093.20.
- For detailed information on the connection of
single controller 7091 or multi-controllers
7092, 7093 and 7094, please refer to the
corresponding operating instructions.
- Please note that in case of a standstill of the
pump, such as in interval operation, fish may
get into the output of the pump, and are injured
when the pump is switched on again.
®
stream 6100/6110
®
Mise en service Turbelle
- raccordez le transformateur (3) sur un réseau
alternatif (5) 230 V 50 Hz (115 V 60 Hz p. USA)
- raccordez les fiches du Singlecontroller
7091 (4) et du transformateur (3) dans les
prises respectives de l'unité de pilotage (2)
puis branchez le transformateur (3) sur le
réseau électrique
- le Kit Turbelle
®
stream 6110 se compose de
®
Turbelle stream
7091 (4)
- Multicontroller 7094 et Singlecontroller 7091
se raccordent directement sur l'unité de
pilotage (2)
- Multicontroller 7093 et 7092 se raccordent
uniquement par l'intermédiaire du Converter
7093.20
- pour plus d'informations concernant
Singlecontroller 7091 ou Multicontroller 7092,
7093 et 7094, veuillez consulter les notices
respectives
®
stream 6100 / 6110
6100 et Singlecontroller
23
Werbung
