Grundfos MAGNA3 Bedienungsanleitung Seite 7

ASSIST
Multi-pump setup
24 h
How to identify the master pump
=
Multi-pump systems
24 h 24 h
= =
Check display to identify the master
=
24 h
pump in multi-pump systems.
=
Master
Twin pump
=
24 h 24 h
Check name plate to identify the
= =
=
master pump on a twin pump.
Master
=
Where to connect Input/output
=
relay
Master Slave
=
Analog input
Digital input
Fieldbus
Master
module(CIM)*
5
Home
Status Settings Assist
Setpoint Control mode
5.00 bar Const. pressure
Operaring mode Actual controlled value
Normal 4.90 bar
XXXXXXXXXXXXXXXXXXXXXXXX
P/N: XXXXXXXX IP XXX TF XXX I [A] P [W] MPa
1 1
S/N: XXXXXXXX
PC: XXXX EEI ≤ X.XX Part X Min. X.XX XXXX
Model: X Made in Germany Max. X.XX XXXX X.X
Grundfos Holding A/S, DK - 8850 Bjerringbro, Denmark
Configure on both
master and slave pump.
Connect and configure
on the master pump.
* If monitoring of the slave pump is desired,
a CIM must be mounted on the slave too.
Multi-pump function
Only one pump is operating at a time.
24 h
The change from one pump to the other
=
Alternating
depends on time or energy. If a pump fails,
operation
the other pump will take over automatically.
24 h
=
Back-up
operation
All pumps in operation will run at equal speed
=
Cascade
and will cut in/out depending on system load.
operation
The Cascade function can be used in control
modes: constant curve and contant pressure.
=
no
Pumps will run as
multi-pump
single pumps.
function
One pump is operating continuously.
The backup pump is operated at
24 h
intervals to prevent seizing up.
If the duty pump stops due to
a fault, the backup pump
will start automatically.
5