Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. BOS-G' fault description
Different types of faults are below:
Fault types
Charge over-current alarm
Charge over-current
protection
Discharge over-current
alarm
Discharge over-current
protection
Charge overtemperature
alarm
Charge overtemperature
protection
Discharge
overtemperature alarm
Discharge
overtemperature
protection
System faults
Charge under temperature
alarm
Charge under temperature
protection
Discharge under
temperature alarm
Discharge under
temperature protection
Excessive differential
voltage alarm
Excessive differential
voltage protection
Excessive differential
temperature alarm
Excessive differential
temperature protection
Cell overvoltage alarm
Cell overvoltage protection
Cell undervoltage alarm
Cell undervoltage
protection
Trigger conditions
Exceeding the parameter set value and set time
(More than 105A, 2s; more than 125A, 5s; more
than 140A, 2s; lower than 5℃,
set value*0.5)
Exceeding the parameter set value and set time
(>45℃, 2s)
Exceeding the parameter set value and set time
(>50℃, 2s)
Exceeding the parameter set value and set time
(>50℃, 2s)
Exceeding the parameter set value and set time
(>55℃, 2s)
Exceeding the parameter set value and set time
(<5℃, 2s)
Exceeding the parameter set value and set time
(<0℃, 2s)
Exceeding the parameter set value and set time
(<-10℃, 2s)
Exceeding the parameter set value and set time
(<-20 ℃, 2s)
Exceeding the parameter set value and set time
(>500mv, 2s)
Exceeding the parameter set value and set time
(>800mv, 2s)
Exceeding the parameter set value and set time
(>10℃, 2s)
Exceeding the parameter set value and set time
(>15℃, 2s)
To maintain consistency, cut off the charging
immediately when the full charge calibration
rated voltage of 3.6V is reached. When the
voltage drops to 3.35V, restart it with the
turned-off red light indicator. All protective red
light indicators are always on!
89
Werbung
