Instructions For Technical Staff; Plumbing Hookup - AFG GSM620-G Handbuch

AfG

4.1 Plumbing hookup

Water supply and drain connection
The water pipelines and electricity supply cable lead out of the bottom
right-hand corner of the appliance. Connect the water intake hose to a
connector with ¾" gas threaded fitting, fitting the filter A provided (in
models with aquastop, the filter and ring-nut form a single unit).
The connection to the water mains must only be made with new hoses;
the use of old or worn hoses is not permitted.
FOR MODELS WITH A WATER SOFTENER
AN 'APPROVED' DOUBLE CHECK VALVE OR SOME OTHER NO LESS EFFECTIVE DEVICE PROVIDING
BACKFLOW PREVENTION PROTECTION TO AT LEAST FLUID CATEGORY TWO SHALL BE FITTED AT THE
POINT OF CONNECTION BETWEEN THE WATER SUPPLY AND THE FITTING OR APPLIANCE.
FOR MODELS WITHOUT A WATER SOFTENER
AN 'APPROVED' SINGLE CHECK VALVE OR SOME OTHER NO LESS EFFECTIVE DEVICE PROVIDING
BACKFLOW PREVENTION PROTECTION TO AT LEAST FLUID CATEGORY TWO SHALL BE FITTED AT THE
POINT OF CONNECTION BETWEEN THE WATER SUPPLY AND THE FITTING OR APPLIANCE.
The dynamic water supply pressure must be between 1 and 6 bar; if it is higher, installation of a
pressure reducer is necessary.
It is essential to fit a main stop tap on the water intake deliver pipeline; the tap must be accessible
after installation of the appliance, so do not install it behind the dishwasher. The stated cycle
duration applies to appliances supplied with hot water >50°C<60°C. If the dishwasher is supplied
with cold water, the cycle duration might increase depending on the intake water temperature. The
dishwasher is fitted with a drain pump and can operate with drain connections on the floor or wall.
Drainage:
The dishwasher is fitted with a drain pump and can operate
with drain connections on the floor or wall.
Caution: make sure that the intake and drain hoses
are not bent, constricted or crushed after
installation.
Warning!
Maximum height of drain hose!

4 INSTRUCTIONS FOR TECHNICAL STAFF

GSM620-G
7