Steam Extraction Time Setting (Optional If Installed); Service Setting (For After-Sales Service Only); Starting The Peristaltic Pumps - Rapid Filling Of Detergent And Rinse Aid Delivery Circuit - AFG GSM620-G Handbuch

AfG

6.14 Steam extraction time setting (optional if installed)

6.15 Service setting (for After-Sales Service only)

6.16 Starting the peristaltic pumps – rapid filling of detergent and rinse aid
delivery circuit.
Perform after the parameter modification procedure explained in the previous point.
With the dishwasher powered up, access "programming
mode" by pressing the on/off
the "beep", release the button and press it again quickly
within 0.5 seconds.
The peristaltic pumps continue to operate until the same
button is pressed again. The rinse aid and detergent symbol
lights remain on as long as the pumps are on; bear in mind
that the rinse aid peristaltic pump fills the circuit in about 7
minutes, while for the detergent it only takes 2 minutes.
GSM620-G
After a few seconds without the user pressing any buttons,
the display will return to the normal operating status and the
modifications will be saved.
Steam extraction system operating time display and setting
button for a few seconds; at
17
See information on AfG