AFG GSM620-G Handbuch Seite 61

AfG
INADEQUATE RINSING
DISHES NOT PROPERLY
DRIED
STAINS ON GLASSES AND
CUTLERY
WATER IN TANK AFTER
PUMP-OUT
GSM620-G
No or not enough detergent
or rinse aid being supplied:
detergent or rinse aid not
being taken from the relative
container.
Plates/glasses badly arranged Arrange plates/glasses correctly.
Low washing temperature
Inappropriate cycle set
Spray arm nozzles fouled
Limescale in boiler
Rinse aid unsuitable or not
being delivered correctly.
Rinsing temperature too low
Rinse aid unsuitable or not
being delivered correctly.
Water hardness above 12°f
or large amounts of dissolved
salts
Drain hose incorrectly
positioned or partially
obstructed.
Drain hose incorrectly
positioned or partially
obstructed.
29
Pipe inside detergent and/or rinse aid
peristaltic pump worn or broke, have it
replaced by the After-Sales Service.
Check temperature shown on the
display, call the after-sales service if
less than 50℃
Increase washing duration, especially if
dishes are very dirty or dirt has dried
on.
- Check that nozzles are clean, and
ensure that the softener is working
properly (if installed).
- Check that the filter of the hose
inserted in the rinse aid tank is not
fouled.
Check container of rinse aid and
whether it is suitable for the type of
mains water. Check boiler temperature
setting. If the problem persists, contact
the after-sales service.
Check container of rinse aid and
whether it is suitable for the type of
mains water. Restore T Stop ON and/or
connect the appliance to a hot water
supply. If the problem persists, contact
the after-sales service.
Check that the dishwasher hose and
drain are unobstructed and the drain is
not too high up; see connection
diagram.
Check that the dishwasher hose and
drain are unobstructed and the drain is
not too high up; see connection
diagram.