Panasonic CQ-RD75LEN Bedienungsanleitung Seite 6

Preset Station Setting
{ FMI FM2 FM3 i AM(LWMW)
«6 Stations a 6 stations {| 6 stations | 6stations§ i
aa
53 AT NAT SEN
co @T =. a=)
w
mao
AF (Alternative Frequency)
Frequency lists for stations with same program
contents.
Press RDS button to switch RDS on (" #35 Oy "is
displayed for 2 seconds.) if you want to listen to the
same program successively as long as RDS fre-
quency on RDS broadcast station is received.
If the AF network on RDS system is not required,
press RDS button again to off. "RIS OFF" is
displayed for 2 seconds.
@ "AF" will not work (even if "RDS" is switched on)
when RDS broadcast station is not transmitting
EON (Enhanced Other Networks)
When receiving RDS station with Enhanced Other
Networks (EON) service available, this unit operates
to renew the built-in frequency lists of the RDS
Station you are listening to, and those of the preset
RDS stations, thus enhancing the AF function.
PS (Program Service Name)
When RDS broadcast station is tuned in, the name
of the station will be shown.
PI (Program Identification)
if the RDS broadcast station is preset and if its
the AF lists. reception is poor when it is called, automatic seek
(P! Seek) will start to tune in to the same program.
y
"RDS? Indicator
"TP" Indicator
Iiluminates when the RDS broad-
cast station is tuned in.
Nluminates when the traffic-intormation broadcast
Station is tuned in.
' 1 To select the desired band
| Press this button to select FMI, FM2, FM3 and AM (LW/MW), (See page 8 about TP mode.)
a a rE Us aN RL OER EeED
|
2 To tune in the desired station. i
| You can tune in a desired station either by manual tuning or seek tuning. '
3 Auto Station Preset i
@ Press the AUTO PRESET button for more than 2 seconds. The six strongest available stations are
automatically set in memory on the preset buttons 1 through 6. Once set, the preset stations are
sequentially scanned for 5 seconds.
@ Press the appropriate preset button for the station you want to hear.
"STDBY" Indicator
Wuminates when the TP, TA or PTY function is
f
4 Manual Station Preset. | stand by.
| Press one of the preset buttons for 2 seconds until the display blinks. The memory has been set. Preset
| Note: When you're in "RDS ON" mode,
"TA" Indicator
other stations on other bands in the same manner.
| auto preset memory only works for RDS
illuminates when the TA function is stand by or
:
TA is tuned in.
stations. When in "TP (ON)" mode, it only
works for TP stations.
To make auto preset for ordinary stations,
switch RDS (TP) to off in advance.
Note: if any of these station selectors is accidentally pressed and held for several seconds, the
previously preset station will be erased; instead, a different station will be registered into that memory
circuit in which the band is playing.
"EON" indicator
lituminates when the Enhanced-Other-Network-
Information broadcast station is tuned in. Qo
ee
OO
gg
oa
oa
Bp
G)
i om
m
2