Werbung
@ Using the Rear Support Strap G:
Affix one end of the Rear Support Strap ©) to the rear of the unit, and the other end to the Fire Wall of Car, or some
other metallic area.
Fire Wall of Car
6-—©® Hex Bok
—@ Tootnhed Lock Washer
2
Hex. Nut
&
———@ Spring Washer
@ Plain Washer
——
-—@© Rear Support Strap
@ Using the Rubber Cushion (Optional)
(if there is an existing Rear Support Bracket on the Fire Wall of Car.)
Cover Mounting Bott @ on the rear of the unit with Rubber Cushion (Optional), and mount it into the existing Rear
Support Bracket.
Rear Support Bracket
(existing on the car}
3. Plug the Power Connector @.
4. After installation reconnect the negative (~) battery terminal.
To Remove the Unit
a) Press the DETACH button to remove the Removabie Face Plate.
b) Insert Dismounting Pin @ into the right hole of the escutcheon. Push the Pin as far as possibie.
_ 0 Dismounting Pin
d) Pull the Pin to remove the unit from the car's dashboard. Supporting the left end of the unit with your other hand,
will facilitate its removal.
Note: Do not lose the Dismounting Pin. It will be needed to remove the unit from the car's dashboard.
N3T9/N310204-0
N3182qH-09
Werbung
