Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTING THE COMPONENTS
CAUTIONS WHEN CONNECTING
e
Do not switch on the power to the stereo amplifier and
e
The "L" and "'R" on the stereo amplifier's input and output
other stereo components until all the connections of the
jacks stand for left channel and right channel respectively.
stereo system have been completed.
e
Connect the pin plugs of the connecting cords securely.
Use the accessory connecting cords which come with each
Otherwise the sound may not be heard or noise will be
of the components (tape deck, tuner, etc.) for the connec-
generated.
tions.
CONNECTING THE SPEAKER SYSTEMS
|
Ss caeeieruisals
There are two sets of spegker output terminals. Use the top
set of terminals (A) when connecting the first set of speakers.
When facing the system (in the listening position), connect
the speaker system on the left to the left channel terminals and
the speaker system on the right to the right channel terminals.
Cautions when connecting the speakers (Fig. 1)
channel speaker
1. The speaker output terminals have polarities: minus (biack)
and plus (red). The input jacks on the speakers also have
plus and minus polarities. When
connecting,
make sure
that these polarities are aligned: plus to plus and minus to
minus. If the left and rignt speaker polarities are misalign-
ed, the reproduced sound will not display a natural stereo
effect.
2. Use speakers with a nominal impedance ranging arom :
All these terminals (B) are used when connecting a second set of
ohms to 16 ohms. But when listening to a program with
speaker systems.
two sets of speakers connected, make sure that the
Fig. 1
nominal impedance is between 12 ohms and 32 ohms.
ys
:
|
Stripping and connecting the speaker cords
Stripping and connecting the speaker cords
(Fig. 2)
Cutter
Twist the strands
aes Co
1. Strip about 10 mm of the covering from the speaker cords.
2. If the strands at the tip of the cord are pointing in all direc-
tions, twist them with your thumb and forefinger. Other-
|
wise some of the strands may come into contact with
other terminals and cords and cause a short.
3. Push down the terminal button, insert the speaker cord in-
to the terminal hole and release the button.
4. Make sure that none of the lead wires in the cords pro-
trude.
|
4)
(2) Insert
—_
(a)
(Push down
|
|
Release
Fig. 2
Werbung
