Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration changed.
The wireless network signal is weak.
The wireless signal is disrupted by another microwave
oven placed near the appliance.
13.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
C2 - the Food sensor is in the appliance cavity during
Pyrolytic Cleaning.
C3 - the door is not fully closed during Pyrolytic Clean‐
ing.
F111 - Food sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect with the
control panel.
When one of these error messages continues to appear on the display, it means a faulty
subsystem may have been disabled. In such a case contact your dealer or an Authorized
Service Centre. If one of these errors occurs, the rest of the appliance functions will continue to
work as usually.
270
ENGLISH
Remedy
Check if your mobile device is connected to the wire‐
less network.
Check your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer
to "Before first use" chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using another microwave oven and the Remote
Control of the appliance at the same time. Microwaves
disrupt Wi-Fi signal.
Remedy
Take out the Food sensor.
Close the door.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
Turn the appliance off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the appliance off and on.
Werbung
