Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
Drive shaft between angle gear box and conditioner in
acc. with lower fig.
Attention:
Ensure profile tubes of pto drive shafts are well
greased at all times! Check a new or repaired ma-
chine and/or drive shaft prior to first run and then
every 20 working hours!
Also ensure sliding surfaces of the protection tubes
are greased!
5.5 Tensioning and greasing the chains
The drive chain can be tensioned by means of the
nylon chain tensioners located under protective
hood (34). Check the chain tension regularly and if a
correction is required loosen the nylon chain tensioner
and push it by hand to a lower position.
Release the securing bolts and nuts (30). Pull out pro-
1
tective hood (34).
Check the chain tension: it will be correct if the chain
2
can still be flexed 1 cm (2,54") at the underside.
Check the tension as follows: release the securing nut
3
(25) of the tensioner (26).
Push down the chain tensioner (26) by hand and hold
4
it fast in this position.
Tighten the securing nut (25).
5
Install the protective hood (34) and tighten the securing
6
bolts and nuts (30).
Oil the chains regularly (see 5.4).
7
5.6 Moving / renewing blade holders
Attention:
-
Always exchange all blade holders per drum!
Ensure the blade holders of a drum skirt have the same
part number! This in order to avoid imbalance!
Renew damaged bolts/nuts as well as all
-
unscrewed lock nuts!
Tighten bolts/nuts in accordance with torque value
-
table of section 5.9!
After some time, wear of the drum skirts may become
apparent at the point where the blade holders are fitted.
Recheck regularly. If this wear is excessive the blade holders
of the drums can be transferred: proceed as follows:
Attention:
Always exchange all blade holders per drum!
Ensure the blade holders of a drum skirt have the
same part number!
This in order to avoid imbalance!
Rotate drums into basic position as shown in fig.
1
Remove skid saucer (see IPL).
2
Attach blade holders at new position.
3
Now move the blade holders of the other drum skirts in
4
order to produce the final situation shown in fig. (or 90°
rotated).
G0202MKD3
34
34
30
30
28
28
27
27
24
24
26
26
25
25
EN19
Werbung
