Vicon CMP 3001F Betriebsanleitung Seite 61

Regularly inspect hydraulic lines (hoses, tubes, connections) and renew when found defective or aged replacement parts
3
shall at least meet the appropriate specifications of the machine manufacturer!
When plugging in the hydr. quick-disconnect plug of a hose always ensure the hydr. socket is not pressurized!
4
Before starting to perform any work at the hydraulic system, stop the tractor engine, lower the machine onto the ground and
5
depressurize the system!
The shut-off valve on the hydr. cylinder must be closed in transport!
6
Position an uncoupled hydr. hose to ensure clean coupling plugs!
7
1.1.4 Balance precautions
Attention:
The following is of major importance as to avoid imbalance. Due to the high speed of the drums it is imperative
they are in balance at all times. All drum skirts are dynamically balanced when manufactured and this balance
must be maintained. Imbalance can cause excessive vibration, wich in turn damages the machines. If during op-
eration an abnormal vibration or a change in the sound noticed, immediately stop machine and find cause!
Prior to commencement of work pay special attention to the following:
Check that the correct number of equally worn blades is fitted on each drum!
1
Check that each drum is fitted with 2 or 4 transport strips (see IPL). These strips must be fitted with the correct bolts . If the trans-
2
port strips wear to such an extent that the drums begin to wear prematurely, then they should be replaced immediately!
Damaged or badly worn blade holders shall be renewed immediately!
3
nsure the blade holders of a drum skirt have the same part number!
E
Damaged of badly worn drums should be renewed immediately!
4
Make sure that the max. pto speed does never exceed 540 or 1000 rpm, depending on the machine type (refer techn.
5
specs.)
1.2 Liability and warranty
In order to ensure safety all persons working at and/or with this machine must read and understand this operation manual.
Furthermore this machine shall always be used, handled and stored in accordance with the design and construction destination
(intended use) which also means:
Exclusively work in accordance with the instructions given in the appropriate Assembly, Operation and Repair Instructions
1
(manuals) including all valid Errata and Supplements as well as taking into account the relevant Service Bulletins; exclusively
use correct tools and equipment being in a perfect condition!
Strictly observe the applicable local regulations concerning safety and accident prevention, generally acknowledged and
2
approved technical, medical and traffic rules as well as the functional limitations and safety instructions stated in above men-
tioned technical documentation!
Do not use any parts (spares, accessories, lubricants) other then those complying with manufacturer requirements. A part
3
complies with manufacturer requirements when either genuine or approved by the manufacturer or when all its properties can
be proven to meet with the appropriate manufacturer requirements for that very use/function!
Only well instructed people being familiar with all possible danger shall work with or at the machine!
4
The machine shall not be used nor transported unless all safety devices (covers, plates, rails, curtains, locks, etc.) are correctly
5
installed and in a perfect condition and set in the appropiate safety position!
All safety decals and signs shall be legible and in the correct place!
Unauthorized modification of or arbitrary changes on the machine or parts of it exclude any responsibility and reliability of
6
the machine manufacturer for the consequences of that operation!
Attention:
Those disregarding above mentioned rules act grossly negligent (careless) through which all manufacturers war-
ranty and reliablility for damages and all other consequences become extinct. The negligent person carries all
risks!
G0202MKD3
Always exchange all blades of a drum!
Always exchange all blade holders per drum!
EN7