Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
MOWING INSTRUCTIONS
3.1 General
Attention:
Check protection prior to commencing work and
1
ensure it is in protective position. Repair or renew
damaged protection!
Repair or renew damaged parts prior to start or
2
continue working with the machine!
Regularly check blade holder pins for deteriora-
3
tion / wear!
Always work using manual throttle control!
4
Select a gear which allows an even stubble to be left.
1
Always use sharp blades for maximum efficiency. Ensure
2
blades are seated correctly over pins of blade holders.
Regularly check blade holders: if pins are more than
half worn (left less than 6.5 mm; 1/4") as shown in fig.
then renew the blade holders! Always exchange all
blades or blade holders resp. per drum skirt! Ensure the
blade holders of a drum skirt have the same part
number! Ensure the crop transport strips have not been
worn too much.
Drums must be rotating at full working speed before
3
entering crop.
The best mowing results will be obtained when the
4
machine is level or pitches just a touch forward (the skid
saucers are then operating in their optimum position).
Adjust as follows:
a) Remove spring clip (9) then release handle (10)
from holder (11).
b) Increase forward inclination: rotate handle (10) cw.
c) Decrease forward inclination: rotate handle (10)
ccw.
d) Reposition handle (10) into holder (11) then safety
spindle by re-insertion of spring clip (9).
Attention:
To prevent recutting of the stubble, the mower should
never be tilted backwards!
Adjust this using the front three-point hitch. Height "B" will
5
then be approx. 90 cm. If desired you can limit this posi-
tion using the optional depth limiting chain.
Ensure the lift cylinder is in floating position when mow-
6
ing.
G0202MKD3
L
37
4
35
2
3
36
B
9
11
11
8
23
23
10
10
21
21
22
22
16
16
o
0
EN11
Werbung
