Werbung
Verfügbare Sprachen
Verfügbare Sprachen
a) Lift machine till jack stand (3) comes free of ground.
5
b) Pull spring clip out of pin (35), remove pin (35) from
lower supports (2).
c) Pull out the jack stand (3) horizontally. Turn the jack
stand 90° to the right. Then lay jack stand at hook (36).
d) Slide the pin (35) through the hole of the upper sup-
ports, then safety by the spring clip.
Pull the blocking pins (43) out and place them in their
6
holder.
Always use stabilisers or check chains to prevent side-
7
ways movement of the machine.
If required fit depth limiting chain (option) (also refer
8
3.1).
2.2 Moving the mower into transport-
position
Pressurize lifting cylinder through control lever. Now
9
the cylinder will fully lift the mower.
Close cock of the lifting cylinder.
10
Lift the mower fully by using the 3-pt front linkage con-
11
trol lever.
37
4
35
2
3
36
B
G0202MKD3
43
o
0
EN10
Werbung
