Hilti DCG 180-P Bedienungsanleitung Seite 30

6. CAUTION Do not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
7. Turn the grinding disc firmly by hand in a clock-
wise direction until the Kwik-Lock nut is tightened
securely and then release the spindle lockbutton.
en
7 Operation
NOTE
Adjust the position of the guard to suit the requirements
of the work being done.
DANGER
Wear ear protectors. Exposure to noise can cause hear-
ing loss.
CAUTION
The closed side of the guard must always face the
operator.
WARNING
Test new cutting or grinding discs by allowing them
to run at maximum speed in a protected area for at
least 30 seconds.
WARNING
Do not use the power tool if it starts with a jolt.This
may be an indication that the electronic control unit is
defective. Have the tool repaired at an authorized Hilti
service center right away.
WARNING
Slits cut in loadbearing walls of buildings or other struc-
tures may influence the statics of the structure, especially
when steel reinforcing bars or load-bearing components
are cut through. Consult the structural engineer, ar-
chitect, or person in charge of the building project
before beginning the work.
WARNING
The electric supply voltage must comply with the in-
formation given on the type identification plate on the
power tool. 230 V power tools may also be connected
to a 220 V supply.
WARNING
Always use the side handle with the power tool.
CAUTION
Use clamps or a vice to hold the workpiece securely.
26
All manuals and user guides at all-guides.com
6.5.2 Removing grinding / cutting discs secured
1.
2.
3.
WARNING
Cutting or grinding may cause splintering of the material.
Wear eye protection.
CAUTION
Breathing protection must be worn if the power tool
is used without a dust removal system for work that
creates dust.
WARNING
Avoid touching rotating parts. Switch the power tool
on only after bringing it into position at the workpiece.
Touching rotating parts, especially rotating insert tools,
may lead to injury.
CAUTION
The insert tool may get hot during use. Wear protective
gloves when changing insert tools.
WARNING
Reduce the load on the power tool by avoiding tilt-
ing the disc in the kerf when cutting. The disc may
otherwise break, or the power tool may kick back or stall.
CAUTION
Improve the blood circulation in your fingers by re-
laxing your hands and exercising your fingers during
breaks between working.
WARNING
Keep inflammable materials away from the working
area.
7.1 Switching on / off
7.1.1 Switching on the DCG 180‑D
WARNING
Test new cutting or grinding discs by allowing them
to run at maximum speed in a protected area for at
least 30 seconds.
1.
2.
with the Kwik-Lock nut
Disconnect the supply cord plug from the power
outlet.
Press the spindle lockbutton and hold it in this
position.
Release the Kwik-Lock nut by turning the knurled
ring in a counter-clockwise direction. (Use the pin
wrench to release the Kwik‐Lock nut if very tight. Do
not use a pipe wrench.)
Plug the supply cord into the power outlet.
Slide the on / off switch forward and then press it as
far as it will go.