Cocraft LXC SA18 Original Bedienungsanleitung Seite 8

Cleaning and storage
• Clean the exterior of the sander with a soft brush or cloth. Never use water,
solvents or corrosive chemicals for cleaning.
• Regularly remove all dirt, especially from around the motor ventilation slits (2).
• Whenever the sander is not to be used for an extended period, the battery
should be removed and it should be stored in a dry, dust-free environment, out of
children's reach.
Emptying the dust collector
1. Remove the battery.
2. Detach the dust collector (5) from the sander (it may be quite tight).
3. Open the collector and empty it.
4. Close the collector and refit it onto the sander.
Troubleshooting guide
The sander •
does not start.
The sander is •
slow and/or •
shuts off.
Poor battery •
operating time.
•
The battery •
does not •
charge.
•
•
•
•
Discharged or incorrectly inserted battery. Charge the battery
and ensure that it is properly fitted to the sander.
Too much force applied. Decrease the applied force.
The battery might be overheated. Refer to the Overload protection
and other safety features section.
The battery is not fully charged. A few charging cycles where
the battery is charged 100% might be needed before it
reaches full capacity.
The battery needs replacing.
The battery is not correctly inserted into the charger.
The battery or charger contacts are dirty. Disconnect the charger
from the power supply and clean the contacts.
The mains lead is not securely plugged into the wall socket.
Check that the wall socket is energised.
The charger or mains lead is damaged.
The battery needs replacing.
8