Scheppach HMS850 Original Bedienungsanleitung Seite 42

• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
16. Trouble Shooting
Problem
Machine cannot be
switched on.
Machine does not work
or stops suddenly
Machine stops during
planing.
Workpiece jams during
thicknessing
Speed decreases when
planing
42 | GB
Possible Cause
• No power supply.
• Carbon brush worn.
Chip extractor not mounted
• Power cut
• Motor or switch defective
• Check microswitch
• Planing blade blunt/worn
• Overload switch has tripped
• Check microswitch
• Too much chip removal
• Too fast feed
• Cutting depth too great
• Too much chip removal
• Too fast feed
• Blunt knives.
www.scheppach.com
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
• Check power supply.
• Take machine to your service point.
• Check fuse, check overload switch on machine.
• Have the motor or switch checked by an elec-
trician.
• Fit the chip extractor hood so that the mi-
croswitch is pressed.
Check fuses.
Due to the integrated lowvoltage protection, the
machine does not restart automatically. Upon
return of the voltage, the machine must be
switched on again.
• Replace or sharpen blade
• Switch on the motor again once it has cooled
• Fit the chip extractor hood or bench lock so that
the microswitch is pressed.
• Reduce chip removal.
• Reduce infeed speed.
• Reduce cutting depth and machine the work-
piece in several passes
• Reduce chip removal.
• Reduce infeed speed.
• Replace knives.