Scheppach HMS850 Original Bedienungsanleitung Seite 33

3. Scope of delivery (Fig. 1a/b)
• Planer/Thicknesser 1x
• Push stick 1x
• Spare-Ripped belt 2x
• Allen wrench 1x
• Crank handle 1x
• Parallel stop 1x
• Chip extractor 1x
• Manual 1x
4. Intended use
The surfacing and thicknessing plane is designed for
the surfacing and thicknessing of all types of whole
pieces of square, rectangular or chamfered converted
timber.
The machine is to be used only for its prescribed
purpose.
m WARNING!
The following work must not be carried out:
• Insert work (in other words any work which does not
extend over the full length of the workpiece)
• Recesses, tenons or cut-outs
• Planing highly warped timber in which there is inad-
equate contact with the feed bench.
m The protective equipment on the appliance is strictly
prohibited to be disassembled, changed, used in con-
flict with the designation and it is prohibited to attach
any protective equipment of other manufacturers.
The bridge guard must not be removed during ma-
chining. The unused part of the blade shaft must be
covered.
Requirements for operating staff
The appliance may only be operated and maintained
by persons familiarised with it and informed about pos-
sible risks.
Never let children work with the appliance. Never let
adults work with the appliance unless they have been
properly trained.
The operating staff must carefully read the Operating
Instructions before using the appliance.
Qualification: Apart from the detailed instructions by
a professional, no special qualification is necessary for
appliance using.
Minimum age: Persons over 18 years of age can only
work on the appliance. An exception includes young-
sters trained in order to reach knowledge under super-
vision of the trainer during occupational education.
Local regulations may stipulate the minimum age of
the user.
Training: Using the appliance only requires corre-
sponding training by a professional or the Operating
Instructions. No special training is necessary.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of mis-
use.
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused as
a result of this.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used
in commercial, trade or industrial businesses or for
equivalent purposes.
5. Important information
General Safety Instructions
WARNING! When using power tools basic safety pre-
cautions should always be followed to reduce the risk
of fire, electric shock and personal injury including the
following.
Read all these instructions before attempting to oper-
ate this product and save these instructions.
Safe operation
1. Keep work area clear
- Cluttered areas and benches invite injuries.
2. Consider work area environment
- Do not expose tools to rain.
- Do not use tools in damp or wet locations.
- Keep work area weil lit.
- Do not use tools in the presence of flammable
liquids or gases.
3. Guard against electric shock
- Avoid body contact with earthed or ground-
ed surfaces (e.g. pipes, radiators, ranges, re-
frigerators).
www.scheppach.com GB | 33