iRobot Combo j9+ Bedienungsanleitung Seite 13

Washing the bin
Important: Do not wash the filter.
Remove the filter before washing the bin.
1
Release the bin, remove the filter and open
the bin door.
2
Rinse the Dust Bin and water tank using
warm water.
Note: The bin is not dishwasher safe.
3
Make sure that the bin is completely dry.
Reinsert the filter and place the bin back
in the robot.
Cleaning the filter
1
Remove the bin. Remove the filter by
grasping both ends and pulling it out.
2
Remove debris by tapping the filter against
your rubbish bin.
3
Reinsert the filter with the ridged grips facing
out. Place the bin back in the robot.
Important: The robot will not run if the filter is
not installed correctly. Replace the filter every
two months.
Cleaning the front caster wheel
1
Pull firmly on the front wheel module to remove
it from the robot.
2
Pull firmly on the wheel to remove it from its
housing (see illustration below).
3
Remove any debris from inside the
wheel cavity.
4
Reinstall all parts when finished.
Make sure that the wheel clicks back into place.
Axle
Housing
Important: A front wheel clogged with hair and
debris could result in damage to your floor. If
the wheel is not spinning freely after you have
cleaned it, please contact Customer Care.
Roomba Combo® j9+ Owner's Guide
EN
Wheel
9