iRobot Combo j9+ Bedienungsanleitung Seite 14

Cleaning the Edge-Sweeping Brush
1
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
EN
2
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
10 For more information, visit global.irobot.com
Cleaning the Dual Multi-Surface Brushes
1
Pinch the brush frame release tab, lift the tab
and remove any obstructions.
3
Remove any hair or debris from the square
and hexagonal pegs on the opposite side of
the brushes. Replace the end caps.
2
Remove the brushes from the robot. Remove
the end caps from the ends of the brushes.
Remove any hair or debris that has collected
beneath the caps. Reinstall the Brush caps.
4
Reinstall the brushes in the robot. Match the shape
of the Brush pegs with the shape of the brush
icons in the cleaning head module.