iRobot Combo j9+ Bedienungsanleitung Seite 16

Care and maintenance instructions for your
Clean Base™ Auto-Fill Dock
To keep your Clean Base™ Auto-Fill Dock running at peak performance, perform
the procedures on the following pages.
EN
Part
Bags
Refill Tank
Charging contacts
Sensors, IR window, Visual
Docking Target
Note: iRobot manufactures various replacement parts and assemblies. If you think that you
need a replacement part, please contact iRobot Customer Care for more information.
*Replacement frequency may vary. Parts should be replaced if there is visible wear.
12 For more information, visit global.irobot.com
Care frequency Replacement frequency*
- Bags should be replaced
when prompted by the
LED indicator/app.
Rinse and refresh water -
as needed
Clean every 2 weeks -
Clean once a month -
Replacing the bag
1
Use the pull tab to open the door
and remove the Debris Bag Drawer.
3
Install a new bag, sliding the
plastic card into the guide rails.
2
Pull the plastic card up to
remove the bag from the
canister. Discard the used bag.
Note: This will seal the bag so that
dust and debris cannot escape.
4
Reinstall the Debris Bag Drawer
and close the door, making sure
that it is completely closed.