AL-KO 32 E Bedienungsanleitung Seite 14

Petrol lawnmower
(stop) according to the desired engine
speed.
Switching on the wheel drive
Applies only to units with a wheel drive!
Do not engage the gears while the engine
is at a standstill!
(Ã
Press the gear switch lever against the upper
handle and keep hold – the gear switch lever does
not lock into position.
Driving speed: approx. 3,7 km/h
Switching off the wheel drive
5Ã
Release the gear switch lever.
Switching off the motor
6Ã
Move the throttle to position
7Ã
Release the engine brake handle.
When the motor has been switched off,
!
the cutter continues running for
several seconds – therefore do not touch the
underside of the mower until the cutter has
come to a standstill!
Setting the cutting height
See installation booklet
All wheels must be at the same height!
Maintenance and care
Before carrying out any maintenance
!
or cleaning work, pull off the spark-
plug connector!
Do not spray the unit with water. Water which
gets into the ignition system or the carburettor
may result in malfunctions.
Clean the unit with a cloth, hand brush, etc.
When the mower is tilted to the side, the
i
carburettor must be pointing upwards!
Expert inspection is required:
n
if the lawn mower strikes an object
n
if the motor stops suddenly
n
if the blade is bent (do not align!)
n
if the motor shaft is bent (do not align!)
n
if the gears are damaged
n
if the V-belt is defective
en-4
Changing the oil / air filter / spark plug
See operating manual supplied by the engine
manufacturer.
Drive gears
The gears are maintenance-free.
Setting the cutting height
See assembly manual
All wheels must be at the same height!
Maintenance and care
!
plug connector!
Do not spray the unit with water.
Water which gets into the ignition system or the
(stop).
carburettor may result in malfunctions.
Clean the unit with a cloth, hand brush, etc.
i
Expert inspection is required:
n
if the lawn mower strikes an object
n
if the motor stops suddenly
n
if the blade is bent (do not align!)
n
if the motor shaft is bent (do not align!)
n
if the gears are damaged
n
if the V-belt is defective
Changing the oil / air filter / spark plug
See operating manual supplied by the engine
manufacturer.
Drive gears
The gears are maintenance-free.
Replacing and resharpening the mowing
blade
At the end of the mowing season always
resharpen the mowing blade or, if required,
replace the mowing blade with a new one.
Always have the mowing blade resharpened
or replaced by a customer service centre
(measurement of imbalance).
!
risk of accident!
Before carrying out any maintenance
or cleaning work, pull off the spark-
When the mower is tilted to the side, the
carburettor must be pointing upwards!
Unbalanced blades will cause the lawn
mower to vibrate violently –
English