Agilent Technologies 8698933R001 Bedienungsanleitung Seite 269

Connection to the Pump
Also the pump cable is shielded and is equipped with ferrite (see the
following picture). Pump cable length must not exceed 1.5 m.
The turbopump is connected to the controller through an 8-pin
connector. Pins B, C and D are the 3-phase supply to the motor, pin E
is connected to the pump ground, pins G and H are not connected,
pins A and F reserved for Agilent.
TV 902 Navigator User Manual / 87-900-999-01
Technical Information
Connection to the Pump
(B)
17
269/276