Before Initial Use; Operation - Klarstein 10004361 Bedienungsanleitung

26. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliances by a person responsible for their safety.
27. Children should be supervised to ensure that they do not play with the appliance.
28. This appliance is intended to be used in household and similar applications such as:
– staff kitchen areas in shops, offices and other working environments;
– farm houses;
– by clients in hotels, motels and other residential type environments;
– bed and breakfast type environments.
29. Save these instructions.
open button
spout
body
power base
If you are using the kettle for the first time, it is recommended that you clean your kettle before
use by boiling a full kettle of water twice and then discarding the water.
1. To fill water into the kettle, remove it from the power base and open the lid by pressing the lid open button , fill with the
desired amount of water to the kettle. Always fill the kettle between the minimum (0.5L) and maximum (1.8L) marks. Too
little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before connecting the power cord to
the outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press the switch button below the handle. The indicating lights inside the kettle
will light up. Then start to boil the water. The kettle will switch off automatically once the water has boiled and the light
extinguishes. You can shut off the power by pressing the switch button at any moment during boiling water.
NOTE：Ensure that switch is clear of obstructions and the lid is firmly closed. The kettle will not turn off if the
switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may result in scald, besides,
don't open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before reopening to boil water.
The kettle may be stored on the power base when not in use.
NOTE：Ensure power supply is turned off when kettle is not in use.
Should you accidentally allow the kettle to operate without water, the boil-dry protection will automatically switch it off. If
this should occur, allow the kettle to cool before filling with cold water and re-boiling.
Kettle

Before initial use

Operation

Boil-dry protect
handle
handle
switch