Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Open filter door.
Take out the flat folded filter.
Illustration
On removing the flat-fold filter, cover
the same immediately with the en-
closed bag and close it.
Order no. bag: 6.592-049.0
Dispose off the used flat-folded filter in
a dust-tight bag according to the statu-
tory provisions.
Remove the dirt that has accumulated
on the pure air side.
Insert new flat-folded filter.
Close the filter door, it must lock into
place.
Push both locking lugs of the filter cover
in with the screwdriver and tighten them
in a clockwise direction.
Replace the disposal bag
Lock parking brakes.
Illustration
Remove the pressure balancing at the
upper end.
Pull the locks of the placement mechan-
ics up.
Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
Pull the container out by the handle.
Illustration
Put the disposal bag over.
Tightly close disposal bag by means of
the closing strip.
Remove disposal bag.
Dispose of the disposal bag according
to the local provisions.
Illustration
Insert the new disposal bag so that it is
snug against the reservoir wall and the
reservoir bottom.
Pull disposal bag over the container.
DANGER
Risk of explosion! The electrostatic earth-
ing between chassis and dirt container via
the spring bow must be ensured.
Reinsert the container and lock it with
the push handle.
WARNING
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mechanism while
locking. Lock the container by pressing the
sliding bow with both hands.
Plug in the pressure balancing.
Replacing the safety filter sack
DANGER
The dust that has been collected should be
transported in dust-proof containers. No re-
filling is permitted. The waste containing
asbestos is to be disposed off according to
the rules and regulations for waste dispos-
al.
DANGER
Only persons trained in waste disposal are
permitted to dispose off the dust collection
container.
Lock parking brakes.
Remove suction hose.
Close the suction connection on the dirt
container, see operation.
Illustration
Remove the pressure balancing at the
upper end.
Pull the locks of the placement mechan-
ics up.
Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
Pull the container out by the handle.
Illustration
Pull over the safety filter sack.
Illustration
Pull out the safety sheet.
Close the safety filter sack using the
self-adhesive flap.
Pull the safety filter sack towards the
rear.
Illustration
Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
– 9
EN
27
Werbung
