Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Close the suction connection
WARNING
Health risk on account of fine dust! If the
suction hose is removed, the suction con-
nection must be closed.
Illustration
Properly insert the connection socket in
the suction connection.
Push in the connection socket until it
locks into place.
Dirt receptacle
Note: The dirt container must be emptied if
it is filled up to the lower edge of the suction
nozzle on the waste container.
– Check the fill level of the dirt container
at regular intervals, as the appliance
does not shut off automatically.
Dry vacuum cleaning
WARNING
– Two suction hoses may not be connect-
ed to the vacuum cleaner at the same
time. One suction nozzle must be tightly
sealed with the connection bushing.
– When using the disposal bag, the lower
suction nozzle must be tightly sealed.
– When using the safety filter bag, the up-
per suction nozzle must be tightly
sealed.
– If the suction hose is connected to the
wrong suction nozzle, a malfunction of
the appliance occurs (automatic moni-
toring of the suction performance does
not respond, increased dust emission,
disposal bag is sucked towards the
top).
Caution: Depending on the application,
the suction hose can be attached to 2
different suction nozzles:
1 Suction nozzle on the intermediate ring:
Dry vacuum cleaning with disposal bag:
Coarse dusts, large quantities of vacu-
umed material over a short period of
time
The appliance is fitted with a disposal
bag, order no. 6.907-347.0 (5 ea.).
2 Suction nozzle on the dirt container:
Dry vacuum cleaning with safety filter
bag: Asbestos, fine particles, constantly
large quantities of vacuumed material
The appliance is equipped with a safety
filter bag with a sealing cap, order no.
6.904-420.0 (5 pcs).
Note: You can use this appliance to take up
all types of dust up to dust class H. The use
of a dust collection bag is required by law.
Note: As an industrial vacuum cleaner the
appliance is suitable for vacuuming up dry,
combustible dusts with MAK values.
Changeover from wet to dry vacuum
cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter element
is still wet the filter will become obstructed
and may be damaged beyond repair.
Dry the wet filter properly before use or
replace it with a dry one.
Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Installing disposal bag/safety filter bag
Lock parking brakes.
Illustration
Remove the pressure balancing at the
upper end.
Pull the locks of the placement mechan-
ics up.
Pull the push handle upward. The con-
tainer is unlocked and lowered.
Illustration
Pull the container out by the handle.
Illustration
Insert the disposal bag so that it is snug
against the reservoir wall and the res-
ervoir bottom.
Pull disposal bag over the container.
Illustration
Insert the safety filter sack.
Illustration
Pull the safety filter sack over the con-
tainer.
– 5
EN
23
Werbung
