Installing The Unit (In-Dash Mounting) - JVC KD-R889BT Bedienungsanleitung

INSTALLATION/CONNECTION

Installing the unit (in-dash mounting)

Orientate the trim plate
as illustrated before
fitting.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might damage
the unit.
Hook on the top side
Bend the appropriate tabs to
hold the sleeve firmly in place.
How to remove the unit
Do the required wiring.
( 32)
Dashboard of
your car
Part list for installation
(A) Faceplate (B) Trim plate
(C) Mounting sleeve (D) Wiring harness
(E) Extraction key
Output terminals
For 2-way crossover setting
3 pairs REAR : Rear output
FRONT : Front output
SW : Subwoofer output
2 pairs FRONT : Front output
REAR/SW : Rear/subwoofer output
1 pair REAR/SW : Rear/subwoofer output
For 3-way crossover setting
3 pairs REAR : Tweeter output
FRONT : Mid Range output
SW : Woofer output
2 pairs FRONT : Mid Range output
REAR/SW : Woofer output
1 pair REAR/SW : Woofer output
31
ENGLISH