Fuxtec FX-RB144 Original Bedienungsanleitung Seite 44

TROUBLE SHOOTING
7.
Problem
Input the correct
password and select
AUTO mode, but the
mower still can not start.
And the charging station
is beeping.
Input the correct
password and select
AUTO mode, but the
mower still can not start.
mower stops and
beeps,AUTO or HOME is
not able to start.
Mower stops working
and beeps.
Mower stops working
and beeps.
Mower stops working
and beeps.
7.TROUBLE SHOOTING
Display
1.Mower has loss contact
with charging station
- 18
Possible reasons
1. The virtual wire fails to
send signals.
2. The virtual wire was
cut off.
1.main power is shut off.
Bad communication
between charging station
and mower.
1. Mower is lifted from
ground.
2. Someone or object ride
or sit on the mower.
1. Running wheel strike
hard objects.
2. The mower is trapped
in lawn.
1. Cutting height is too low.
2. Blade strikes hard
objects.
3. Mower is trapped in lawn
-
Solutions
1. Check the virtual wire
light on charging station.
Be sure the virtual wire is
connected to the charging
station well (light in
colorless).
2. Connect the virtual wire
with wire connectors.
1. Check the power and
make sure the charger is
connecting well with power
supply and charging
station.
1.Make sure charging
station is power on and the
virtual wire is connected
2.match address between
mower and station,refer to
5.6Address setting.
1. Take the mower to level
ground and restart it.
2. Take the object away
from mower and restart it.
1. Clean thelawn andmake
sure it is free from hard objects.
2. Clean the lawn where
mower is trapped or restart
the mower in another place.
1. Adjust the cutting height
to suitable height.
2. Clean the lawn
make sure it is free from hard
objects.
3. Clean the lawn where
mower is trapped or restart
the mower in another place.
and