Fuxtec FX-RB144 Original Bedienungsanleitung Seite 33

Virtual wire installation
3.4
The virtual wire can be installed in one of the
following ways:
Securing the wire to the ground with pegs.
-
It is preferable to staple down the virtual wire, if you
want to make adjustments to the virtual wire during
the first few weeks of operation.
Bury the wire
-
It is preferable to bury the virtual wire(max depth: 5cm)
if you want to detach or aerate the lawn.
If necessary both methods can be combined so one
part of the virtual wire is stapled down and the
remainder is buried.
Install virtual wire with pegs 1 meter apart.
-
It's best to use smooth radius corners than
sharp angles. See pictures.
10cm
Passage or
a ground with
same level
of the lawn.
House, wall, fence or
other obstacle higher
than the lawn
3. INSTALLATION
OK
40cm
Min40cm
Location
- Bury virtual wire below grass and fasten it on
the ground with pegs, so that the mower should
not cut the wire.
virtual wire
IMPORTANT
Hard or dry ground may cause pegs to break when
driving them in. In extreme cases, watering the lawn
where the pegs will be driven.
- A minimum distances between the front of the charging
station and an obstacle is 2 meters. And make sure the
distance from corner to front of charging station is at least
2.5 meters. Make sure to lay a 2.5 meters minimum
straight-light of virtual wire in front of charging station.
- If a high obstacle, for example a house, wall, fence or
other obstacle which is higher than the cutting lawn
borders the working area, the virtual wire should be laid
at least 40cm from the obstacle. This will prevent mower
from colliding with the obstacle.
- If a passage or a ground with same height of cutting lawn,
the virtual wire should be laid at least 10cm from the edge.
- A minimum distance between the pool edge of virtual
wire is 40cm.
- A minimum distance between two corners is 1meter.
>90
Min:40cm
Max:1cm
Pool
Straight-line
at
- 7 -
Add pegs in order to pull the
virtual wire down to the ground
surface, below the grass tips.
INFORMATION
- A maximum distance of the virtual wire
to and from the island is 1cm, and fix the
two wires with one peg.
- There are two types of set up of the
virtual wire around the charging station.
Put the charging station near corner.
please take location for reference.
Please make sure to set a straight-line
at least of 2.5m in front of charging
station. The charging station should be
far away from puddle.