Address Setting; Emergency Switch - Fuxtec Fx-Rb144 Original Bedienungsanleitung

5. USE
IMPORTANT INFORMATION
- Do not leave the mower to operate unattended if you
know that there are pets, children or people in the
vicinity
- Mow only in daylight or in good artificial light.
- Avoid operating the mower in wet grass.
- Do not operate the mower when barefoot or wearing
open sandals.
- Always wear substantial footwear and long trousers.
- Always be sure of your footing on slopes.
- Use extreme caution when reversing the mower
towards you.
- Always switch on the mower according to
instructions with feet well away from the blade.
WARNING
Read the safety instructions before you start
your mower.
WARNING
Keep your hands and feet away from the
rotating blade. Never put your hands or feet
close to or under the body when the motors
are running.
5.1 Preparation
- Ensure the correct installation of the virtual wire.
- Periodically inspect the area where the mower
is to be used and remove all stones, sticks, wires,
bones, and other foreign objects especially the height
of objects is less than 6cm.
- Periodically visually inspect that the blades, blade
bolts and cutter assembly are not worn or damaged.
Replace worn or damaged blades and bolts in sets
to preserve balance.
- Connect the two ends of virtual wire to the terminal
on charging station, and ensure virtual wire is in good
connecting. (Light on charging station is colorless).
- Insert charger into charging station and secure it with
threaded cap. And then connect charger to power
supply. Ensure the charging station has a good connection
and the light on charging station is Green.
- Periodically inspect the lawn is without any small
hole or mound.
IMPORTANT INFORMATION
User can not start the mower if virtual wire or
charging station is not in good connecting.
5. USE
5.2 Starting the mower
There are two locations of start the mower.
1. Take the mower clockwise onto virtual wire, make sure
that the mower is not connected with two charging
sheets on charging station. Otherwise, the mower is in
recharging Mode, it can not be started.
2. Take the robot to start point.
To set LINE
directly.
To set LINE
cutting for one circle, and finish cutting on the virtual
wire first.
To start the robot.
1. Turn on the Power button under the mower. 2.Press
the Emergency button to turn on the robot.
3. Input Password (Initial password:1234) if selected.
4. Select AUTO
5. Can select workingtime(10-500mins)wheninto auto mode.
Note:If the mower lost contact with station, AUTO or HOME
mode is not able to start.The display will show:
Then need match the address between mower and station,
please refer to section
Stopping mower /Turning off mower
5.3
1. Press power button from APP. Mower
stops and enters standby mode.
2. The mower can be turned off by pressing the
Emergency button directly.
3. Press power button under the mower to turn off.

Emergency Switch

5.4
Press Emergency button at any time the mower power
off at once. User has to restart it.
- 13 -
off, the robot begins cutting inside lawn
on, the robot will follow the virtual wire
mode, the mower start working.

5.6 Address setting