AEG NIG85M30AB Benutzerinformation Seite 176

Problem
The display does not react to the
touch.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
You cannot activate the highest heat
setting.
The sensor fields become hot.
Hob²Hood does not work.
Hob²Hood screen is not visible.
Hob²Hood operates, but only the
light is on.
Hob²Hood Modes 1 - 6 operate, but
the light is off.
There is no sound when you touch
the panel sensor fields.
Wrong language was set.
176 ENGLISH
Possible cause
The fuse is blown.
You did not set the heat setting for
60 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
Part of the display is covered or the
pots are placed too near to the dis‐
play.
There is some liquid or an object on
the display.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor under the hob surface is dam‐
aged.
Another zone is already set to the
highest heat setting.
The FlexPower level is too low.
The cookware is too large or you put
it too near to the controls.
You covered the control panel.
Hob²Hood is turned off in the set‐
tings.
You activated Mode 1.
There might be a problem with the
light bulb.
The sounds are deactivated.
You changed the language by mis‐
take.
Remedy
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 60 seconds.
Touch only one sensor field.
Refer to "Daily use".
Remove the objects. Move the pots
away from the display.
Clean the display, wait until the ap‐
pliance is cold. Disconnect the hob
from the electrical supply. After 1
min, connect the hob again.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
First reduce the power of the other
zone.
Change the maximum power in the
Menu. Refer to "Before first use".
Put large cookware on the rear
zones, if possible.
Remove the object from the control
panel.
Go to settings/Hob²Hood and acti‐
vate the function.
Change the mode to Mode 1 - Mode
6or wait until the automatic mode
starts.
Contact an Authorised Service Cen‐
tre.
Activate the sounds. Refer to "Daily
use".
Follow the instruction in "Daily use",
"Language" to change the wrong
language.