AEG NIG85M30AB Benutzerinformation Seite 175

Cooker hoods with the Hob²Hood function
To find the full range of cooker hoods which
work with this function refer to our consumer
8. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
8.1 General information
• Clean the hob after each use.
• Always use cookware with a clean base.
• Scratches or dark stains on the surface
have no effect on how the hob operates.
• Use a special cleaning agent suitable for
the surface of the hob.
• Always use a scraper recommended for
hobs with a glass surface. Use the scraper
only as an additional tool for cleaning the
glass after the standard cleaning
procedure.
WARNING!
Do not use knives or any other sharp,
metal tools to clean the glass surface.
• For the metal side trim, use only a
dishwashing detergent with warm water.
Use a cloth to clean and wipe the trim.
WARNING!
Do not use the mildly abrasive
cleaning milk, any polishing
detergents, scrapers, or the hard layer
of a sponge to clean the side trim.
9. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
9.1 What to do if...
Problem
You cannot activate or operate the
hob.
website. The AEG cooker hoods that work
with this function must have the symbol
• The gap between the glass surface and
the side trim may gather dirt and small
particles of food. Use a wooden toothpick
to clean the gap between the glass
surface and the side trim.
Do not use any sharp metal tools to
clean the gap as they may widen the
gap and damage the side trim or the
glass surface.
8.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, salt, sugar and food with sugar,
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
at an acute angle and move the blade on
the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and a non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
• Remove shiny metallic discoloration:
use a solution of water with vinegar and
clean the glass surface with a cloth.
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
WARNING!
Remedy
Check if the hob is correctly connec‐
ted to the electrical supply. Refer to
the connection diagram.
.
ENGLISH 175