Axkid ENVIROBABY Bedienungsanleitung Seite 14

Buckle your child in the seat and adjust to fit
1 Put the infant car seat on a flat surface. Create slack on the belt by using the harness adjustment button (L) and pulling the
shoulder belt (O) at the same time until it is fully pulled out. Open the belt buckle (M) and fold away the harness (O).
Axkid recommends using the baby insert (J) if your child is approximately between 0-3 months to ensure an appropriate fit.
2
When your child is approximately 3 months old, remove the insert.
Place your child in the infant car seat. Make sure there are no blankets or thick clothing between the child and the back of the
3
infant car seat.
4
Place the shoulder belts over your child' s shoulders, as close to the neck as possible.
5
Lock the harness (O) by pushing the two connectors together and then insert them into the belt buckle (M).
Check the belt position in relation to the child. The belt position should be just above the child' s shoulders. Check this regularly
6
as your child grows. If needed, adjust the belt position according to step 7.
Pull the belt height adjustment knob (R) outwards, slide the belt carrier (Q) up or down and release the knob in the position best
7
suitable for your child. Make sure the belt height adjustment knob springs back into a locked position.
8
Pull the belt adjustment strap (K) to tighten the harness (O).
9
There should be approximately 1 cm of space between the child' s shoulders and the belt.
IMPORTANT
• When tightening the harness, it is important that you have the infant car seat on a flat surface. The child' s position could be very
different if the infant car seat is angled which may cause the harness to be insufficiently tightened.
• Make sure the belt is not twisted in any way.
Adjusting the handle
To adjust the handle (A), press both handle adjustments buttons (I) simultaneously and at the same time, push the handle in the direction
of intended movement. The handle has three different positions (A1, A2 and A3) with different purposes:
A1 This position shall be used when carrying the child or when mounting the infant car seat in the vehicle.
A2 This position shall be used when using the infant car seat as a cradle or when mounted in a compatible stroller.
This position blocks the cradle function and can be used when you want the cradle function disabled, for example when feeding
A3
your child.
WARNING: The handle is an important safety feature and must always be in position A1 when Envirobaby is used in a vehicle.
14