Error Codes - Dometic POWER & CONTROL NBC Montage- Und Bedienungsanleitung

EN

Error codes

Problem
The output LED indicator lights up
red.The battery charger switches off
automatically.
The input LED indicator lights up red.
The battery charger switches off auto-
matically.
The input LED indicator flashes red
quickly. The battery charger switches
off automatically.
One of the LED indicators flashes slow-
ly red. The battery charger switches off
automatically.
20
Possible cause
The battery charger has detected a
short circuit of a connected device on
the output side.
The AC input is unstable.
The battery charger has detected a
short circuit of a connected device on
the input side.
The input fuse has blown.
The battery connected to the IBS is
overheated (>52 °C).
Lead Acid, AGM and GEL batteries
only: The battery connected to the
IBS is underheated (<-18 °C).
LiFePO4 battiers only: The battery
connected to the IBS is underheated
(<-20 °C).
The battery charger is overheated
(>90 °C).
The battery voltage of the correspond-
ing battery that is charged is too high.
The corresponding battery does not
reach the charging current and there-
fore not the charging phases U and
U0.
Suggested remedy
Replace the short circuited de-
vice.
LiFePO4 batteries only: If the
battery charger is connected to
an AC source, reset the AC con-
nection.
Reconnect the D+ connection.
Reconnect the AC input.
If necessary, disconnect the AC
source and connect the battery
charger to a DC source.
Replace the short circuited de-
vice.
Reset the connected device.
Let the corresponding battery
cool down below 45 °C.
Refer to the manufactures in-
structions.
Move the corresponding battery
to a warmer place.
Ensure that the corresponding
battery has a temperature above
-10 °C.
Refer to the manufactures in-
structions.
Move the corresponding battery
to a warmer place.
Ensure that the corresponding
battery has a temperature above
-15 °C.
Refer to the manufactures in-
structions.
Let the battery charger cool
down below 50 °C.
If the battery charger is connect-
ed to an AC source, reset the AC
connection.
If the battery charger is connect-
ed to a DC source, ensure that
the battery voltage is below
15.7 V.
If the battery charger is connect-
ed to an AC source, reset the AC
connection
Reconnect the D+ connection.