EKVIP 025893 Bedienungsanleitung Seite 10

EN
3. Carefully screw the light back on its base.
Do not overtighten, this can damage the
thread.
Remote control (transmitter)
1. Push the battery cover on the back of
the remote control in the direction of
the arrow and remove it. Remove the
discharged batteries.
2. Insert two 1.5 V batteries AAA with the
correct polarity as shown by the markings
(+/–) in the battery compartment.
3. Replace the battery cover.
NOTE:
Always replace both batteries at the same
time. Do not mix new and old batteries,
or different types of batteries.
USE
BEFORE USE
1. The lights are fastened on the branches of
the tree with clips in the base.
2. Check that the lights are firmly in place.
3. Make sure there are no obstructions
between the remote control and the
lights. The range of the remote control
will be reduced if the charge level of
the batteries is low, or if there are
obstructions between the remote control
and the lights.
ON/OFF
• Press "ON" to switch on the lights.
• Press "OFF" to switch off the lights.
• Press "TIMER" for the lights to stay on for
6 h, they will then stay off for 18 h.
10