Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Inflate the tyre to the maximum pressure indicated on the tyre wall so that the
tyre sits evenly on the rim.
A "plop" sound is normal.
•
Then lower the pressure to the desired value (refer to section 4.1.).
•
Screw the valve cap onto the valve.
5.6.4. Fitting the rear wheel
Position the rear wheel beneath the dropouts and, very carefully to begin with, fit
the belt onto the rear socket without twisting.
•
Lift the belt onto the front socket without
twisting and place the rear wheel in the frame
dropouts. Ensure that the brake disc slides
between the brake pads.
•
Now remove the spacer being used for support (e.g. the beverage crate) so that
the rear wheel is lowered down onto the ground.
•
Check fastening of the tab washers. These should be seated securely in the drop-
outs.
•
Tighten the axle nuts with a tightening torque of 40 Nm.
•
Insert the connector at the NuVinci hub interface so that it clicks into place. At
the same time, ensure that the arrow markers line up with one another.
5.6.5. Adjusting the Enviolo gear hub
The gear shift quality of the Enviolo gear hub may decrease while the vehicle is in
use. You can correct this by adjusting the shift cable clearance.
•
You can feel the shift cable clearance by gently
pulling on the end caps of the gear cables that
run into the twist grip.
•
A clearance of 0.5 mm per pull is ideal. More
than 2 mm clearance can adversely affect the
gear shift quality of the system and the service
life of the shift cable.
•
To adjust this, turn both set screws and check the amended clearance.
0,5 mm
69
Werbung
