Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To adjust the height of the stem, proceed as follows:
•
Loosen the 4 marked screws on both sides
until the stem can be turned.
•
Set the desired handlebar angle.
•
Tighten the screws again with 14-15 Nm.
In a second step, the handlebar must be twisted in the opposite direction:
•
Loosen all 4 screws on the clamping plate of
the stem until the handlebar can be turned.
•
Turn the handlebars to the desired position.
•
Tighten all 4 handlebar clamping screws of
the stem with 6 Nm.
3.3.
Adjusting grip distance of the brake lever
The grip distance can be adjusted using an Allen
key at the position marked in red.
The grip distance of the brake lever should be
adjusted so that it is possible to wrap the foremost
phalanges of 2-3 fingers behind the brake lever.
4.
Before every ride
4.1.
Checking the tyres
Tire pressure:
Schwalbe prescribes 2-4 bar as the permissible pressure range for all tyres.
With a maximum load of 200 kg, you should inflate all 3 tyres to 4 bar. At lower loads
you can reduce the pressure.
60
Werbung
