HNF-NICOLAI CD2 Cargo Originalbetriebsanleitung Seite 59

3. Ergonomic setting
3.1. Horizontal saddle position and tilt
The optimum horizontal saddle position can
be determined using the "knee plumb line".
The knee plumb line can be determined using
a weight suspended on a piece of string. The knee
plumb line should pass through the pedal axle or
just in front of it.
Sit on the CD2 in the position shown above with horizontal crank arms and have
a second person determine the knee plumb line.
Ideally, the saddle is horizontally aligned with the upper side or with the saddle tip
tilted slightly forwards.
To adjust the saddle position and tilt, loosen the
two Allen screws of the saddle clamp, which are
located in front of and behind the seatpost under
the saddle.
You can now
guide of the clamp and adjust the tilt.
Then tighten both screws with 9-10 Nm.
3.2. Stem adjust
The CD2 Cargo is equipped with a height-adjustable stem. On delivery, the stem is
screwed in the lowest position (-20°).
By changing the angle of the stem (max. angle +40°), the height of the handlebars can
be increased by up to 40 mm.
shift the saddle in the
59