Assembly; Adhesive Mounting - Abus Rwm250 Bedienungs-, Installations- Und Wartungsanleitung

ASSEMBLY

The smoke alarm is held in place by
a magnetic holder attached to the
mounting site. Please note that the
magnetic holder only has a strong
magnetically attractive force from one
direction. The magnetic holder may
either be mounted by an adhesive
fixing or by drilled holes:

1. Adhesive mounting

1.1 Adhesive mounting with fasteners
Magnetic holder, self-adhesive
coated in accordance with
EN14604:2005/AC:2008
Warning: The sole use of this self-
adhesive fastener produces a
• very maintenance-friendly
• stable
• magnetic connection of the device
to the installation site
• The device can be detached from
the magnetic holder by gently
pulling it downwards e.g. for
inspection, maintenance or
cleaning
For this adhesive mounting, only the
supplied adhesive may be used.
The assembly site must be
• firm
• dry
• free of dust, grease or loose paint,
etc.
Application:
a) Remove the information sticker and
the protective film from the applied
adhesive material (Fig. 3) on the
magnetic holder.
b) Press the adhesive surface of the
magnetic holder firmly onto the
mounting surface for approx.
10 seconds.
c) Place the device on the magnetic
holder.
d) The adhesive bond will reach its
ultimate strength after approx.
72 hours.
e) If required, the device can be remo-
ved from the magnetic holder by
pulling it gently in a vertical motion.
Fig.. 3
– 26 –
1.2 Adhesive mounting with optional
fixing device in addition to 1.1
(thin double-sided adhesive film)
in accordance with vfdb (German
Fire Protection Association) 14/01
(Q) and EN14604:2005/AC:
Warning: The additional use of this
optional adhesive produces an
• extremely stable
• and long-lasting connection bet-
ween the device and the fixture
and thus with the mounting base.
• The device can no longer be remo-
ved by pulling it from the magnetic
holder (this means significantly
greater security against unautho-
rised removal, theft etc.)
Only use this method of fixing when
you are absolutely certain that the
device must remain permanently
fixed and that it should not be
removed.
Be certain to note that this is a very
strong fixing; the unit can only be
removed with great effort and possi-
ble damage to the mounting site
and to the device. We accept no
liability for any damage incurred !
For this adhesive mounting, only the
supplied adhesive may be used.
The assembly site must be
• firm
• dry
• free of dust, grease or loose
paint, etc.
Application:
a) Remove the information sticker
and the protective film from the
applied adhesive material (Fig. 3)
of the magnetic holder.
b) Press the adhesive surface of the
magnetic holder firmly onto the
mounting surface for approx.
10 seconds.
c) Remove the first protective film
from the thin double-sided adhe-
sive film and press this firmly,
smoothly and flush onto the entire
metal surface of the smoke alarm.
d) Now remove the second protective
film from the thin double-sided
adhesive film and place the device
onto the pre-mounted magnetic
holder while applying gentle
pressure.
– 27 –
GB