Start Up; Function; Alarm And Indication Sounds - Abus Rwm250 Bedienungs-, Installations- Und Wartungsanleitung

START UP

First of all, please remove any activa-
tion safeguards (e.g. a black activation
safety device) and make sure that the
activation safeguard does not get into
the device! Then, press the device's
red activation button (Fig. 1, I.) which
is shown in the picture on page 3.
After being pressed, this button must
be flush with the housing of the
device. To confirm that your smoke
alarm is now activated, a short test
tone will sound after activation. This
test tone is repeated when you press
the test/stop button (IV.) and is an
indication that the device is ready for
operation.

FUNCTION

Heat warning function:
• Heat warning function is triggered
at 60°C
• Single beep every second

ALARM AND INDICATION SOUNDS

Indication sounds:
When the device is activated,
a single sound is emitted (short
beep).
Volume:
Cause: Activation tone
Indication sounds:
When the test/stop button is
pressed, a single sound (long beep)
is emitted.
Volume:
Cause: Test tone
– 22 –
Alarm sounds:
A double sound is emitted (short
beep, longer beep) every second.
0,5 second
Volume:
Cause: Smoke alarm
Alarm sounds:
A single sound is issued every
second (short beep).
1 second
Volume:
Cause: Temperature alarm
Silencing the alarm
sounds
Every alarm sound can be tempo-
rarily deactivated by pressing the
test / stop button (Fig. 1, IV.)
(smoke alarm and temperature
alarm: 10 min.).
Indication sounds:
A single sound is emitted every
90 seconds (short beep).
90 second
Volume:
Cause:
Battery error message
If the smoke alarm emits one of the
two indication sounds described
above, the device will remain capa-
ble of providing its warning func-
tion for a maximum of 60 days and
must therefore be replaced before
this emaining 60-day period expires!
– 23 –
10 min
GB