cecotec CONGA CONNECTED GYRO Bedienungsanleitung Seite 57

6. TROUBLESHOOTING
Beeps while the indicator light is red:
Beeps Error
Driving-wheel
1
fault
2 Side brush error.
Fan error
3
4 Main-brush fault.
Other possible scenarios:
Problem
The robot vacuum
cleaner does not
activate.
The robot vacuum
cleaner suddenly
stops working.
The programming
function does not
work.
Suction power level is
very low.
The robot vacuum
cleaner does not
charge.
Solution
Check if the drive wheel is blocked.
Check if the side brushes are blocked and clean them.
Clean the dust or objects that may be blocking the air inlet
channel.
Check if the main brush is blocked or tangled and clean it.
Solution
Make sure the battery is fully charged.
If the problem persists, reset the robot vacuum cleaner by
pressing the RESET button.
Check if the robot vacuum cleaner is trapped or stuck with any
obstacle.
Check the battery level.
If the problem persists, turn the robot off and then on again. If the
issue persists, press the RESET button.
Check if the robot vacuum cleaner battery is too low to turn on.
Check if there are obstructions blocking the air inlet.
Empty the tank.
Clean the filters with a vacuum cleaner or a self-cleaning brush.
Check if the filters are wet.
Leave the filters to dry naturally before reinstalling them. Make
sure they are completely dry to prevent any remaining moisture
to reach the motor and damage the robot vacuum cleaner.
Check if the charging base indicators are on. Otherwise, contact
the official Technical Support Service of Cecotec.
Clean the charging terminals with a clean, dry cloth.
Check if the robot vacuum cleaner beeps when it gets to the
charging base. Contact the official Technical Support Service of
Cecotec.
ENGLISH
CONGA CONNECTED GYRO
57