OHAUS Frontier FC5720R Bedienungsanleitung Seite 23

EN-16
TM
Frontier Centrifuges
A-2
A-1
1
1
4
5
Figure. 33
4.1.5 Song selection for sound signal - end of run
Proceed as described under point 4.1.1to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "G". with the adjusting knob (1). As
a result, in the display "RPM | RCF" (A-1), the word "SonGo/Sound" appears. After pressing the key "RPM |
RCF" (4), you can select a song with the adjusting knob (1). (See figure 34).
After you have stored the settings (see 4.1.1) you can change back to the normal program mode again by switch
off the centrifuge for a short while.
A-2
A-1
1
Figure. 34
4.1.6 Keyboard sound turn on / off
Proceed as described under point 4.1.1to enter this program mode and then press the key "Accel/Decel" (5). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "B". with the adjusting knob (1). As
a result, in the display "RPM | RCF" (A-1), the word "ON/BEEP " appears. After pressing the key "RPM | RCF"
(4), you can turn the keyboard sound (On) or (Off) with the adjusting knob (1). (See figure 35).
After you have stored the settings (see 4.1.1) you can change back to the normal program mode again by switch
off the centrifuge for a short while.