Endress+Hauser RIA14 Kurzanleitung Seite 38

Operating the field indicator
Menu
1) Only, if DIM = TEXT
2) Only, if NAMUR = Edit
3) only available for service personnel
6.4 Configuration via interface & FieldCare Device Setup PC configu-
ration software
WARNING
L
The device is not explosion-protected when the housing is open.
‣
The device must be configured outside the hazardous area.
The device can assume undefined states while configuring with FieldCare! This can result in
the undefined switching of outputs and relays.
To configure the device with the FieldCare Device Setup software, connect the device to your
PC. You need a special interface adapter for this purpose - the Commubox FXA291.
The 4-pin connector of the interface cable must be plugged into the corresponding socket
inside the device and the USB connector must be plugged into a free USB slot on the PC.
6.4.1 Connection establishment
When connecting the device, the device DTM is not automatically loaded in FieldCare, i.e. the
device has to be added manually.
Online configuration is not possible with the RIA14/RIA16.
• Firstly, add the Communication DTM "PCP (Readwin) TXU10 / FXA291" to an empty project.
• In the Comm DTM settings, set the baud rate to 2400 baud and select the COM-port used.
• Add the RIA14/16 Version Vx.xx.xx device DTM to the project using the "Add device..."
function.
• To then configure the device itself, follow these Operating Instructions for the device. The
entire Setup menu, i.e. all the parameters listed in these Operating Instructions, can also be
found in the FieldCare Device Setup.
38
Operating function
Parameter Default /
Choice
----
Operating function
Parameter Default /
Choice
yes YES
no NO
RIA14
Operating function
Parameter Default /
Choice
Endress+Hauser