Endress+Hauser Deltabar S PMD70 Austauschanleitung Seite 11

Exchange of sensor unit on Deltabar S PMD70
Adjustment / Calibration
After the assembly has been completed the instrument is operable again.
Calibration for software Version 1.x
• After the instrument has been powered up, a reset
É
operation menu
The previous sensor calibration data are still stored in the electronic module.
• If a sensor with a different range has been installed, an additional "
Therefore enter Code 1209
The electronics then reads all new sensor specific data from the sensor electronics.
• If a sensor assembly with a different range has been installed, the instrument must be calibrated to the new measuring range
according to the manual.
• If the product structure of the instrument changes after the exchange of a sensor unit (i.e. a different measuring range), an additional
modification type plate must be installed at the housing.
Calibration for software Version
• After the instrument has been powered up, a reset
É
operation menu
The previous calibration data are deleted in the electronic module.
• If a sensor assembly with a different range has been installed, the instrument must be calibrated to the new measuring range
according to the manual.
• If the product structure of the instrument changes after the exchange of a sensor unit (i.e. a different measuring range), an additional
modification type plate must be installed at the housing.
Table: error rate after mounting
measuring range
delta p
25 mbar
30 mbar
500 mbar
3 bar
1) zero errors can be compensated for in the operating menu
group calibration field position calibration
Endress+Hauser
É
operation in field " reset
in the same field.
≥
2.x
É
operation in field " reset
1
error rate [mbar]
exchange after exchange
assembly complete of sensor or gasket
no error
no error
no error
no error
Code 7864 (general reset) must be entered in the
".
sensor adaptation reset
Code 7864 (general reset) must be entered in the
".
3 mbar
3 mbar
3 mbar
3 mbar
KA603P/00/a2/12.06
" must be performed.
5