Belt Tracking Adjustment - capital sports Pacemaker X20 10026914 Bedienungsanleitung

Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt
clockwise reasonably and inspect for proper tension. When an adjustment is made to the belt tension,
you must also make a tracking adjustment to compensate for the change in belt tension.
Note: DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature
bearing failure.

Belt tracking adjustment:

This treadmill is designed to keep the belt reasonably centered while in use. It is normal for some belts to
drift near one side while the belt is running with no one on it. After a few minutes of use, the belt should
have a tendency to center itself. If during use, the belt continues to move toward one side, adjustments
are necessary.
The procedures are as below:
1. First set speed at lowest position.
2. Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen
the left bolt by using Hexagonal Wrench, until
the belt is centered itself; If belt shifts to left, tighten the
left bolt and loosen the right bolt by using 6mm
Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the Hexagonal Wrenches, it
is important to adjust the belt in half turn increments. Over
adjusting the belt can cause damage to the
mat.
45