Data Logger; Settings - Pce Instruments Pce-T 420 Bedienungsanleitung

7

Data logger

With the help of the data logger function, measured values can be logged over a defined period
of time. A total of 100 slots are available in the memory for the saved data records. The PC
software must be used to display the data records.
7.1

Settings

The same settings are used for logging as for regular measurement mode. These can be set in
the Measurement menu. The settings specific to data logger mode are in the Data Logger menu.
The memory interval can be set between 1 s and 12 h. This means that the measured values are
only saved at the set interval. The measured value displays update during logging at the same
rate as in regular measuring mode.
The data logger can be started in two different ways. This can be done manually via the REC key
or a start time can be set via the Start condition menu.
There are three different options for stopping the data logger, which can be selected via the Stop
condition menu. Either the stop can be initiated manually via the REC key, at a specific time or
after an adjustable time interval.
The start and stop conditions can be combined in any way.
When selecting date/time for the start or stop condition, the start of the data logger is prevented
if the set start/stop time is before the current time or the stop time is before the start time. In this
case, the corresponding settings must be checked and corrected.
After the desired data logger settings have been selected, the data logger can be started.
© PCE Instruments
35